The SBFTF1010-130 Redundant Link Protector is a 10/100 Ethernet fault-tolerant transceiver that significantly reduces network down time by adding a new level of redundancy to 10/100 Ethernet connections. The Redundant Transceiver has three ports: one for the critical (main) device, one for the default (primary) path to the critical device, and another (backup) for the backup path. It is a smart device that will not send any signal on a path that is inactive. If the primary path loses its link, then the transceiver will switch to the backup path in approximately 189 milliseconds.
When the primary path re-establishes its link, the Redundant Link Protector will automatically switch back to the primary path. Optional functionality, controlled via a dip switch, allows the unit to move from the fault-tolerant mode to a 3-port switch mode.
Features
- Fault-tolerant redundant connections
- Easy to install and use
- Supports half and full-duplex transmission
- Auto-MDI/MDIX
- Auto-Negotiation
- IEEE 802.3 compliant
- 9 diagnostic LEDs
- Optional 3-port switch mode
SBFTF1010-130 Tech Specs
Standards
- IEEE 802.3
Connectors
- Type: 8-position, RJ-45 receptacle:
- 1: TX+5: NC (no connection)
- 2: TX-6: RX-
- 3: RX+7: NC (no connection)
- 4: NC (no connection)
- 8: NC (no connection)
Data Rate
- 10/100 Mbps
Dip Switch
- SW1 (TP): Auto-Negotiation enable/disable
- SW2 (TP): 10Mbps or 100 Mbps
- SW3 (Fiber): Half or Full-duplex
- SW4: Redundancy/Switch
System LEDs
- Power (PWR): Indicates the presence of POWER
- Primary (PRI): Indicates a link is established on the Primary port
- Backup (BKP): Indicates the link has moved over to the Backup port
Port LEDs
- Lower Right:
- Green indicates 100 Mbps;
- Orange indicates 10 Mbps;
- Flashing indicates Activity
- Lower Left:
- Green indicates full-duplex; Off half-duplex
Dimensions
- Width: 3.25” [82.55 mm]
- Depth: 4.8” [121.92 mm]
- Height: 1″ [25 mm]
Power Consumption
- 2.4 Watts
Power Input
- 120 VAC @ 60 Hz. (Domestic)
- 100 – 240 VAC @ 50 Hz. (International)
Power Output
- 12 VDC, 0.5 Amp (Domestic)
- 12 VDC, 1.25 Amp (International)
Environment
- Operating: 0°C to 50°C
- Storage: -15°C to 65°C
- Humidity: 5% to 95% (non-condensing)
- Altitude: 0 – 10,000 ft.
Weight
- 2 lbs. [0.90 kg]
Certifications
- Safety: Wall Mount Power Supply: UL Listed & CSA certified; FCC Class A, EN55024, EN61000, CE Mark
